Subaru Outback (BR): Airbag System
READ NEXT:
A: COMPONENT
Front sub sensor RH
Front sub sensor LH
Airbag warning light (in combination meter)
Airbag module ASSY (driver)
Airbag module ASSY (passenger)
Airbag co
A: PROCEDURE
1. POWER SUPPLY
1) How to disconnect:
CAUTION: When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.
Push the lock (A).
W
A: REPLACEMENT
Replace the following parts if the airbag has been activated.
1. FRONT COLLISION
1) Driver's airbag module.
2) Passenger's airbag module.
3) Driver's seat belt (pretensioner).
4) Pas
SEE MORE:
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically. Pull the bulb straight downward to remove it.
3. Install a new bulb.
4. Reinstall the lens.
1. Apply the parking brake.
2. Turn off unnecessary lights and accessories.
3. Depress the clutch pedal to the floor and shift the shift lever into neutral.
Hold the clutch pedal to the floor while starting the engine. The starter motor
will only operate when the clutch pedal is depressed full
© 2010-2026 Copyright www.suoutback.com
