Subaru Outback (BR): Airbag System (Diagnostics)
READ NEXT:
A: PROCEDURE
Check List for Interview
A: CHECK
Identification
A: PROCEDURE
Identify the vehicle using the chassis number, part number of the airbag control module or Subaru Select Monitor.
A: PROCEDURE
For operation procedures, refer to "Airbag Connector" of Airbag System. <Ref. to AB-18, Airbag Connector.>
Airbag Control Module I/O Signal
A: ELECTRICAL SPECIFICATION
SEE MORE:
● Promptly wipe the aluminum wheels clean of any kind of grime or agent. If dirt
is left on too long, it may be difficult to clean off.
● Do not use soap containing grit to clean the wheels. Be sure to use a neutral
cleaning agent, and later rinse thoroughly with water. Do not clean
A: REMOVAL
1) Lift up the vehicle, and then remove the front wheels.
2) Remove the front arm.
Remove the nut and disconnect the front stabilizer link.
Remove the bolt, and then remove the ball joint for the front arm.
Remove the bolts, then remove the front arm.
B: INSTALLATION
1) Before i
© 2010-2026 Copyright www.suoutback.com
