Subaru Outback (BR): Combination meter illumination
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Meters and gauges / Combination meter illumination
When the ignition switch is turned to the “ON” position, the various parts of the combination meter are illuminated in the following sequence.
1. Warning lights, indicator lights, meter needles, gauge needles, odometer and trip meter back light illuminate.
2. Meter needles and gauge needles each show MAX position.
3. Meter needles and gauge needles each show MIN position.
4. Dials and indicators in meters and gauges light up.
5. Regular illumination (for driving) begins.
NOTE
The above sequence of operations may not take place if you quickly turn the ignition switch to start the engine. This is not a malfunction.
READ NEXT:
Canceling the function for meter/gauge needle movement upon turning on the ignition
switch
It is possible to activate or deactivate the movement of the meter needles and
gauge needles that takes place when the ignition switch is turned to the “ON” position.
1. Turn the ignition swi
Speedometer
The speedometer shows the vehicle speed.
Odometer
This meter displays the odometer when the ignition switch is in the “ON” position.
The odometer shows the total distance that the vehicle has been driven.
If you press the trip knob when the
SEE MORE:
Air cleaner element
WARNING
Do not operate the engine with the air cleaner element removed. The air cleaner
element not only filters intake air but also stops flames if the engine backfires.
If the air cleaner element is not installed when the engine backfires, you could
be burned.
CAUTION
When replacing the a
Rear Drive Shaft, General Diagnostic Table
A: REMOVAL
1) Lift up the vehicle, and then remove the rear wheels.
2) Remove the axle nut.
CAUTION: Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub bearing.
Lift the crimped section of axle nut.
Remove the axle nut using a socket wrench while de
© 2010-2026 Copyright www.suoutback.com
