Subaru Outback (BR): Defrosting or defogging the windshield
Subaru Outback (BR) 2010-2015 Owners Manual / Climate control / Manual climate control system (if equipped) / Heater operation / Defrosting or defogging the windshield
To direct warm air to the windshield and front door windows:
1. Set the air inlet selection button to the OFF position.
2. Press the “
” button.
3. Turn the temperature control dial all the way to the right.
4. Set the fan speed control dial to the highest speed.
READ NEXT:
Heating and defrosting
To direct warm air toward the floor and the windshield:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the temperature control dial to the most comfor
Heating
To direct warm air toward the floor:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the temperature control dial to the most comfortable level.
4. Se
Bi-level heating
This setting allows you to direct air of different temperatures from the instrument
panel and foot outlets. The air from the foot outlets is slightly warmer than from
the instrument panel outlets.
SEE MORE:
Trunk Lid
A: REMOVAL
1. TRUNK LID DAMPER STAY
1) Open the trunk lid.
2) Remove the trunk lid damper stay.
Float the lock pin using a flat tip screwdriver, etc. and slide it.
Remove the trunk lid damper stay by pulling the damper stay mounting
point.
2. TRUNK LID HINGE
1) Open the trunk lid.
2) Remove
Oil Charge Pipe
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the under cover. <Ref. to EI-35, REMOVAL,
Front Under Cover.>
4) Remove the front exhaust pipe. <Ref. to
EX(H6DO)-5, REMOVAL, Front Exhaust Pipe.>
5) Disconnect the connector from turbine speed
© 2010-2025 Copyright www.suoutback.com
