Understanding the ABS Warning Light in Your Subaru Outback (BR)
ABS warning light serves as an essential indicator of the Anti-Lock Braking System's operational status in your Subaru Outback (BR). When you turn the ignition switch to the “ON” position, the ABS warning light illuminates briefly for approximately 2 seconds, demonstrating that the ABS system is functioning as intended. This initial illumination and subsequent turning off of the warning light signify that the ABS system has completed its self-check and is ready for use.
However, there are specific scenarios where the ABS warning light's behavior may indicate a need for attention and repair. If the ABS warning light fails to illuminate at all when you turn the ignition switch to the “ON” position or remains illuminated even after your vehicle has exceeded approximately 12 km/h (8 mph), it's advisable to have the ABS system inspected and repaired promptly by an authorized SUBARU dealer.
Similarly, if the ABS warning light illuminates while you're driving or starts flashing, it could be a sign of an ABS system malfunction. In such cases, while the ABS function may be temporarily disabled, your conventional brake system will continue to operate normally, ensuring your safety on the road.
It's worth noting that there are instances where the ABS warning light's behavior is considered normal and doesn't indicate any underlying issues with the ABS system. For example, if the ABS warning light illuminates immediately after starting the engine but then turns off quickly and remains off, or if it comes on while driving but then promptly turns off and remains off, these are typically normal occurrences and don't require immediate action.
Additionally, during certain situations such as jump-starting your vehicle when the battery voltage is low, the ABS warning light may illuminate due to the reduced battery voltage. This is not a malfunction but rather a response to the temporary low voltage. Once the battery is fully charged, the ABS warning light should turn off automatically, indicating the restoration of normal operating conditions.
In summary, while the ABS warning light in your Subaru Outback (BR) serves as a crucial indicator of the ABS system's functionality, understanding its different behaviors and knowing when to seek professional attention can help ensure the continued safety and reliability of your vehicle's braking system.
hen driving with an insufficient battery voltage such as when the engine is jump started, the ABS warning light may illuminate. This is due to the low battery voltage and does not indicate a malfunction. When the battery becomes fully charged, the light will turn off.
READ NEXT:
Brake system warning light
WARNING
● Driving with the brake system warning light on is dangerous. This indicates
your brake system may not be working properly. If the light remains illuminated,
have the brakes insp
Parking brake warning
The light illuminates with the parking brake applied while the
ignition switch is in the “ON” position. It turns off when the parking brake is
released.
Brake fluid level warning
This light illuminates when the brake fluid level has dropped
to near the “MIN” level of the brake fluid reservoir with the ignition switch in
the “ON” position and with the parking brake
SEE MORE:
Satellite radio reception
Satellite radio signals are best received in areas with a clear view of the open
sky. In areas where there are tall buildings, trees, tunnels or other structures
that may obstruct the signal of the satellites, there may be signal interruptions.
Other circumstances that may result in signal los
Spot Map Light
A: REMOVAL
NOTE:
The spot map light is a single unit with the overhead console.
1) Disconnect the ground cable from battery.
2) Remove the overhead console assembly.
Push and open the rear end of the overhead console lid, and remove the
screws.
Remove the clips and pull out the overhead consol
