Subaru Outback manuals

Subaru Outback (BR): Cooling or dehumidifying

For cooling and dehumidification of the passenger compartment, air flows through the instrument panel outlets: 1. Set the air inlet selection button to the OFF position.

2. Press the “3. Set the air conditioner button to the “ON” position.” button.


3. Set the air conditioner button to the “ON” position.

4. Set the temperature control dial to the blue side.

5. Set the fan speed control dial at the desired speed.

READ NEXT:

 Defrosting or defogging

To direct warm air to the windshield and front door windows: 1. Press the “” button. 2. Set the temperature control dial to the red side. 3. Set the fan speed control dial at the highest speed.

 Automatic climate control system (if equipped)

NOTE ● Operate the automatic climate control system when the engine is running. ● The blower fan rotates at a low speed when the engine coolant temperature is low. For efficient defog

 Automatic climate Control panel

  1) Temperature control button (driver’s side) 2) Dual mode button 3) Airflow mode selection button 4) Fan speed control button 5) Temperature control button (front passenger’s s

SEE MORE:

 To hook the top tether

CAUTION Always remove the head restraint when mounting a child restraint system with a top tether. Failure to do so may prevent the top tether from being fastened tightly. Outback 1. Remove the head restraint at the seating position where the child restraint system has been installed with t

 SRS airbag system warning light

When the ignition switch is turned to the “ON” position, the SRS airbag system warning light will illuminate for approximately 6 seconds and turn off. This shows the SRS frontal airbag and SRS side airbag and SRS curtain airbag and seatbelt pretensioners are in normal operation. WARNING

© 2010-2026 Copyright www.suoutback.com