Subaru Outback (BR): Fuel filler lid and cap
READ NEXT:
Only one person should be involved in refueling. Do not allow others to approach
the area of the vehicle near the fuel filler pipe while refueling is in progress.
Be sure to observe any other preca
WARNING
Testing of an All-Wheel Drive vehicle must NEVER be performed on a single two-wheel
dynamometer. Attempting to do so will result in uncontrolled vehicle movement and
may cause an accident
You should perform the following checks and adjustments every day before you
start driving.
1. Check that all windows, mirrors, and lights are clean and unobstructed.
2. Check the appearance and c
SEE MORE:
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover. <Ref.
to EI-64, REMOVAL, Instrument Panel Lower Cover.>
3) Disconnect the connector from clutch switch.
4) Remove the clutch switches.
B: INSTALLATION
1. CLUTCH SWITCH
1) Move the clevis pin
1. Pull off the fender lining. For details, refer to “Pulling off the fender
lining” F11- 7.
2. Remove the bulb cover, by turning it counterclockwise.
3. Disconnect the electrical connector.
4. Remove the retainer spring.
5. Replace the bulb, then set the retainer spring securely.
© 2010-2026 Copyright www.suoutback.com
