Subaru Outback manuals

Subaru Outback (BR): Replacing the battery

CAUTION

● Do not let dust, oil or water get on or in the transmitter when replacing the battery.

● Be careful not to damage the printed circuit board in the transmitter when replacing the battery.

● Be careful not to allow children to touch the battery and any removed parts; children could swallow them.

● There is a danger of explosion if an incorrect replacement battery is used. Replace only with the same or equivalent type of battery.

● Batteries should not be exposed to excessive heat such as sunshine, fire or the like.

If the transmitter fails to operate when used within the standard distance, this may indicate a weak battery. Replace the battery as soon as possible. The battery can be replaced by your authorized SUBARU dealer. If you replace the battery by yourself, use utmost care that no dust, oil or water enters the transmitter.

To replace the battery:

1. Remove the screw on the key head.


1. Remove the screw on the key head.

2. Open the key head using a flat-head screwdriver.


2. Open the key head using a flat-head screwdriver.

3. Remove the transmitter case from the key head.


3. Remove the transmitter case from the key head.

4. Open the transmitter case by releasing the hooks.


4. Open the transmitter case by releasing the hooks.

1) Negative (−) side facing up


1) Negative (−) side facing up

5. Replace the old battery with a new battery (Type CR1620 or equivalent) making sure to install the new battery with the negative (−) side facing up.

6. Put together the transmitter case by fitting the hooks on the case.

7. Reinstall the transmitter case in the key head.

8. Reinstall the screw on the key head.

After the battery is replaced, the transmitter must be synchronized with the remote keyless entry system’s control unit. Press either the “or “” button six times to synchronize”
or “the unit.” button six times to synchronize
the unit.

READ NEXT:

 Replacing lost transmitters

If you lose a transmitter or want to purchase additional transmitters (up to four can be programmed), you should reprogram all of your transmitters for security reasons. It is recommended that you

 Programming the transmitters

The remote keyless entry system is equipped with a special code learning feature that allows you to program new transmitter codes into the system or to delete old ones. The system can learn up to

 Deleting old transmitter codes

The control unit of the remote keyless entry system has four memory locations to store transmitter codes, giving it the ability to operate with up to four transmitters. When you lose a transmitter

SEE MORE:

 Checking the oil level

Check the engine oil level at each fuel stop. 1. Park the vehicle on a level surface and stop the engine. If you check the oil level just after stopping the engine, wait a few minutes for the oil to drain back into the oil pan before checking the level. 2. Pull out the level gauge, wipe it c

 Rear center seating position

CAUTION The head restraint is not intended to be used at the lowest position. Before sitting on the seat, raise the head restraint to the extended position.   A) When not used (retracted position) B) When used (extended position)   1) Head restraint 2) Release button To raise:

© 2010-2026 Copyright www.suoutback.com