Subaru Outback (BR): Vehicle Dynamics Control system monitor
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Vehicle Dynamics Control system / Vehicle Dynamics Control system monitor
- Vehicle Dynamics Control warning light/Vehicle Dynamics Control operation indicator light
- Vehicle Dynamics Control OFF indicator light in Subaru Outback (BR)
READ NEXT:
Vehicle Dynamics Control warning light/Vehicle Dynamics Control operation indicator
light
The light illuminates when the ignition switch is turned to the “ON” position
and turns off several seconds after the engine has started. This lighting pattern
indicates that the Vehicle Dyn
Vehicle Dynamics Control OFF indicator light in Subaru Outback (BR)
The light will turn on when the ignition switch is set to the "ON" position and will automatically turn off after about 2 seconds. Additionally, the light will illuminate if the Vehicle Dy
Vehicle Dynamics Control OFF switch
Pressing the switch to deactivate the Vehicle Dynamics Control system can facilitate
the following operations.
● a standing start on a steeply sloping road with a snowy, gravel-covered, or
SEE MORE:
MT Gear Select Cable
A: REMOVAL
CAUTION:
Always use new MT gear select cable if the cable is removed from selector lever
COMPL of transmission
side.
1) Disconnect the ground cable from battery.
2) Remove the ten clips and remove the grille bracket.
3) Remove the air intake duct.
Non-turbo model
<Ref. to IN(H4S
Instrument Panel Lower Cover
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the clips, and remove the instrument panel side cover LH.
3) Remove the instrument panel lower cover.
Remove the clips and data link connector, and remove the instrument
panel lower cover under.
Remove the screws and clips a
© 2010-2026 Copyright www.suoutback.com
