Subaru Outback (BR): Glass/Windows/Mirrors
READ NEXT:
A: COMPONENT
1. FIXED GLASS (SEDAN MODEL)
Windshield glass
Dam rubber
Molding
Seal upper side
Locating pin
Rearview mirror mount
Rear window glass
Seal A
A: LOCATION
NOTE: For other related fuses, refer to the wiring diagram. <Ref. to WI-15, Power Supply Circuit.>
B: INSPECTION
1. CHECK FUSE.
1) Remove the fuse and check visually.
2) If
A: REMOVAL
1) Remove the front door trim. <Ref. to EI-60, FRONT DOOR, REMOVAL, Door
Trim.>
2) Remove the sealing cover.
CAUTION:
Carefully remove the butyl tape. Excessive force will easily
SEE MORE:
This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to “Immobilizer” F2-3. If the indicator light does not flash, it may
A: REMOVAL
NOTE:
The spot map light is a single unit with the overhead console.
1) Disconnect the ground cable from battery.
2) Remove the overhead console assembly.
Push and open the rear end of the overhead console lid, and remove the
screws.
Remove the clips and pull out the overhead consol
© 2010-2026 Copyright www.suoutback.com
