Subaru Outback (BR): Initialization of power window
If the vehicle’s battery is disconnected due to situations such as battery or
fuse replacement, the following functions are deactivated.
● One-touch auto up/down function
● Anti-entrapment function
Initialize the power window in the following procedure to reactivate such functions.
1. Close the driver’s door.
2. Turn the ignition switch to the “ON” position.
3. Open the driver’s side window halfway by pushing down the power window switch.
4. Pull up the power window switch and close the window completely. Continue pulling
up the switch for approximately 1 second after the window is closed completely.
READ NEXT:
The rear gate can be locked and unlocked using any of the following systems.
● Power door locking switch: Refer to “Power door locking switches” F2-7.
● Remote keyless entry system
WARNING
Never let anyone’s hands, arms, head or any objects protrude from the moonroof.
A person could be seriously injured if the vehicle stops suddenly or turns sharply
or if the vehicle is i
SEE MORE:
Each brief press of the “TUNE/TRACK/ CH” dial changes the control modes in the
following sequence.
Choose the desired level for each mode by turning the “TUNE/TRACK/CH” dial. The
control function returns to the tune/ track/channel control mode after approximately
5 seconds.
A: REMOVAL
1) Remove the front wheels.
2) Fully open the front hood.
3) Disconnect the ground cable from battery.
4) Remove the collector cover.
NOTE:
Follow the steps below when removing the collector
cover.
Pull up the two points at the rear (A).
Pull up the two points at the front (B) whil
© 2010-2026 Copyright www.suoutback.com
