Subaru Outback (BR): Operating tips for heater and air conditioner
Subaru Outback (BR) 2010-2015 Owners Manual / Climate control / Operating tips for heater and air conditioner
- Cleaning ventilator grille
- Efficient cooling after parking in direct sunlight
- Lubrication oil circulation in the refrigerant circuit
- Checking air conditioning system before summer season
- Cooling and dehumidifying in high humidity and low temperature weather condition
- Air conditioner compressor shut-off when engine is heavily loaded
- Refrigerant for your climate control system
READ NEXT:
Cleaning ventilator grille
Always keep the front ventilator inlet grille free of snow, leaves, or other
obstructions to ensure efficient heating and defrosting. Since the condenser is
located in front of the radiator, thi
Efficient cooling after parking in direct sunlight
After parking in direct sunlight, drive with the windows open for a few minutes
to allow outside air to circulate into the heated interior. This results in quicker
cooling by the air conditioner.
Lubrication oil circulation in the refrigerant circuit
Operate the air conditioner compressor at a low engine speed (at idle or low
driving speeds) a few minutes each month during the off-season to circulate its
oil.
SEE MORE:
Front Door Glass
A: REMOVAL
1) Remove the front door trim. <Ref. to EI-60, FRONT DOOR, REMOVAL, Door
Trim.>
2) Remove the sealing cover.
CAUTION:
Carefully remove the butyl tape. Excessive force will easily break
the cover.
If cover gets broken, replace it with a new part.
3) Remove the inner pad.
4)
Rear Gate
A: REMOVAL
CAUTION:
Rear gate panels are heavy. When removing and installing them, always work in a
team of two or
more persons.
1. REAR GATE PANEL
1) Disconnect the ground cable from battery.
2) Remove the following parts. <Ref. to EI-164, REMOVAL, Rear Gate Garnish.>
Rear gate trim
Rear
© 2010-2026 Copyright www.suoutback.com
