Subaru Outback manuals

Subaru Outback (BR): Precautions to observe when handling a compact disc

Subaru Outback (BR) 2010-2015 Owners Manual / Audio / Precautions to observe when handling a compact disc

Use only compact discs (CDs, CD-Rs and CD-RWs) that have the mark shown in the following illustration. Also, some compact discs cannot be played.


● You cannot use a DualDisc in the CD player. If you insert a DualDisc into the


● You cannot use a DualDisc in the CD player. If you insert a DualDisc into the player, the disc may not come out again, possibly causing the player to malfunction.

● In cold and/or rainy weather, dew can form inside the CD player, preventing normal operation. If this happens, eject the CD and wait for the player to dry out.

● Skipping may occur when the CD player is subjected to severe vibration (for example, when the vehicle is driven on a rough surface).

● To remove a disc from the case, press the center of the case and hold both edges of the disc. If the disc surface is touched directly, contamination could cause poor tone quality. Do not touch the disc surface.

● Use a clean disc whenever possible. If there are deposits, wipe the disc surface from the center outward with a dry, soft cloth. Be sure not to use a rough cloth, thinner, benzine, alcohol, etc.

● Do not use any disc that is scratched, deformed, or cracked. Also, do not use any disc that has a non-standard shape (for example, a heart shape). Malfunctions or problems might result.

● A disc is vulnerable to heat. Never keep it either in places exposed to direct sunlight, near heaters or in vehicles parked in the sun or on hot days.

● Insert discs one by one into the CD player.

Audio control buttons (if equipped)


READ NEXT:

 Audio control buttons (if equipped)

Type A audio Type B audio These buttons are located on the spokes of the steering wheel. They allow the driver to control audio functions without taking his/her hands off the steering wheel.

 MODE button

This button is used to select the desired audio mode. Each time it is pressed, the mode changes to the next one in the following sequence. *1: The frequency last received in the selected waveba

 “up” and “down” switch

With radio mode selected Press the switch to the “” or “” side briefly to skip to a preset channel. Press the switch to the “” or “” side for more than 0.5 second to seek the

SEE MORE:

 Stop Light Switch

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Remove the instrument panel lower cover. Remove the clips, and remove the instrument panel side cover LH. Remove the clips and data link connector, and remove the instrument panel lower cover under. Remove the bolts, and remove

 Replacing the battery

CAUTION ● Do not let dust, oil or water get on or in the transmitter when replacing the battery. ● Be careful not to damage the printed circuit board in the transmitter when replacing the battery. ● Be careful not to allow children to touch the battery and any removed parts;

© 2010-2024 Copyright www.suoutback.com