Subaru Outback manuals

Subaru Outback (BR): Tires specification in the table

Subaru Outback (BR) 2010-2015 Owners Manual / Specifications / Tires specification in the table

*1: This torque is equivalent to applying approximately 88 to 110 lbf (40 to

 

*1: This torque is equivalent to applying approximately 88 to 110 lbf (40 to 50 kgf) at the end of the wheel nut wrench. If you have tightened the wheel nuts by yourself, have the tightening torque checked at the nearest automotive service facility as soon as possible.

*2: For the wheel nut tightening procedure, refer to “Changing a flat tire” F9-6.

READ NEXT:

 Wheel alignment

Item Legacy Outback 2.5 L non-turbo models Except 2.5 L non-turbo models  

 Fuses and circuits

 Fuse panel located in the passenger compartment

SEE MORE:

 Pulling off the fender lining

It is necessary to pull off the fender lining when replacing some bulbs. 1. Start the engine and turn the steering wheel fully in the opposite direction of the bulb to be replaced. 2. Stop the engine. 3. Remove the clip from the fender lining. Refer to “Type B clips” F11-5. 4. Pull off

 Steering Wheel

A: REMOVAL 1) Disconnect the negative terminal from the battery, and wait for 60 seconds or more. 2) Set the tire to the straight-ahead position. 3) Remove the driver's airbag module assembly. Push in the snap pin using a hexagon wrench or equivalent wrapped with a protective tape to disengag

© 2010-2025 Copyright www.suoutback.com