Subaru Outback manuals

Subaru Outback (BR): To decrease the speed (by brake pedal)

1. Depress the brake pedal to release cruise control temporarily.

2. When the speed decreases to the desired speed, press the “RES/SET” switch to the “SET” side once. Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal.

READ NEXT:

 Cruise control indicator light

The cruise control indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds. The light illuminates when the “CRUISE”

 Cruise control activation indicator light

The indicator light for cruise control activation illuminates upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds. This light becomes illuminated

 Driving tips

SEE MORE:

 Checking the fluid level when the fluid is cold

When the fluid level has to be checked without time to warm up the automatic transmission, check to see that the fluid level is between the lower level and upper level on the “COLD” range. If it is below that range, add fluid up to the upper level. Be careful not to overfill. CAUTION Be

 Ignition Switch Illumination

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Remove the steering column cover. Remove the screws by turning the steering wheel to right and left. Release the claws and remove the steering column lower cover. Separate the steering column upper cover and steering upper cover,

© 2010-2026 Copyright www.suoutback.com