Subaru Outback (BR): To change the cruising speed
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Cruise control / To change the cruising speed
- To increase the speed (by the “RES/ SET” switch)
- To increase the speed (by accelerator pedal)
- To decrease the speed (by the “RES/SET” switch)
- To decrease the speed (by brake pedal)
READ NEXT:
To increase the speed (by the “RES/ SET” switch)
Press the “RES/SET” switch to the “RES” side and hold it until the vehicle reaches
the desired speed. Then, release the switch. The vehicle speed at that moment will
be memorized and tre
To increase the speed (by accelerator pedal)
1. Depress the accelerator pedal to accelerate the vehicle to the desired speed.
2. Press the “RES/SET” switch to the “SET” side once. Now the desired speed is
set and the vehicle will keep
To decrease the speed (by the “RES/SET” switch)
Press the “RES/SET” switch to the “SET” side and hold it until the vehicle reaches
the desired speed. Then, release the switch. The vehicle speed at that moment will
be memorized and tre
SEE MORE:
Yaw Rate and G Sensor
A: NOTE
Yaw rate & longitudinal G and lateral G sensor are integrated with the VDC
control module & hydraulic control
module (VDCCM&H/U).
B: INSPECTION
1. YAW RATE & LONGITUDINAL G AND LATERAL G SENSOR SIGNAL
Steering Angle Sensor
A: REPLACEMENT
1) Position the front wheels straigh
Continuously Variable Transmission Mounting System
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the center exhaust pipe. <Ref. to EX(H4SO)-8, REMOVAL, Center Exhaust Pipe.>
4) Remove the heat shield cover.
5) Set the transmission jack under the transmission. Make sure that the support plate
© 2010-2026 Copyright www.suoutback.com
