Subaru Outback (BR): Unfastening the rear seatbelts seatbelt

Push the button on the buckle.
Before closing the door, make sure that the belts are retracted properly to avoid
catching the belt webbing in the door.
READ NEXT:
1) Center seatbelt tongue plate
2) Connector (tongue)
3) Connector (buckle)
4) Center seatbelt buckle
WARNING
Fastening the seatbelt with the webbing twisted can increase the risk or severity
Push the release button of the center seatbelt buckle (on the left-hand side)
to unfasten the seatbelt.
1. Insert a key or other hard pointed object into the slot in the connector (buckle)
To clean the seatbelts, use a mild soap and lukewarm water. Never bleach or dye
the belts because this could seriously affect their strength.
Inspect the seatbelts and attachments including the web
SEE MORE:
The light will turn on when the ignition switch is set to the "ON" position and will automatically turn off after about 2 seconds. Additionally, the light will illuminate if the Vehicle Dynamics Control OFF switch is pressed to deactivate the Vehicle Dynamics Control system in Subaru Out
A: PROCEDURE
NOTE: When the sunload sensor check is performed indoors or in the shade, it could be diagnosed as sensor having an open circuit. Always perform the inspection in direct sunlight.
General Description
A: CAUTION
1) Never connect the battery in reverse polarity.
Doing so may
© 2010-2026 Copyright www.suoutback.com
