Subaru Outback (BR): Acc
In this position the electrical accessories (radio, accessory power outlet, etc.) can be used.
READ NEXT:
ON
This is the normal operating position after the engine is started.
START
CAUTION
Do not turn the ignition switch to the “START” position while the engine is running.
The engine is started in this position. The starter cranks the engine to start
it. When the key is
Key reminder chime
The reminder chime sounds when the driver’s door opens and the key is in the
“LOCK” or “Acc” positions. The chime stops when the ignition switch is turned to
the “ON” position or the
SEE MORE:
Inspection Mode
A: PROCEDURE
Perform the diagnosis shown in the following DTC table.
When performing the diagnosis not listed in "List of Diagnostic Trouble Code (DTC)",
refer to the item on the
drive cycle. <Ref. to EN(H4SO)(diag)-45, Drive Cycle.>
1. PREPARATION FOR THE INSPECTION
MODE
1) Check that the
Battery (inspection, removal, installation)
A: REMOVAL
1) After disconnecting the battery ground terminal, remove the terminal cover, then disconnect the positive terminal.
2) Remove the battery cable holder from the battery rod.
3) Remove flange nut from the battery rod and remove battery holder.
Remove the battery.
B: INSTALLATION
© 2010-2026 Copyright www.suoutback.com
