Subaru Outback (BR): Body Control System (Diagnostics)
READ NEXT:
A: PROCEDURE
CAUTION:
Subaru Select Monitor is required for reading DTC, performing diagnosis and reading current data.
Remove foreign matter (dust, water, oil, etc.) from the body in
A: LIST
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
A: DTC B1100 INTEG. UNIT SYSTEM ERROR
DTC DETECTING CONDITION:
System error in body integrated unit
TROUBLE SYMPTOM:
LAN communi
SEE MORE:
A: PROCEDURE
Perform the diagnosis shown in the following DTC table.
When performing the diagnosis not listed in "List of Diagnostic Trouble Code (DTC)",
refer to the item on the
drive cycle. <Ref. to EN(H4SO)(diag)-45, Drive Cycle.>
1. PREPARATION FOR THE INSPECTION
MODE
1) Check that the
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the engine.
3. Remove the clip from the fender lining. Refer to “Type B clips” F11-5.
4. Pull off
© 2010-2026 Copyright www.suoutback.com
