Subaru Outback (BR): Door open indicator light
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / Door open indicator light
When any of the doors, the rear gate (Outback) or the trunk lid (Legacy) is not fully closed, the door open indicator light illuminates. This function is effective even if the ignition switch is in the “LOCK” or “Acc” position or the key is removed from the ignition switch.
The open door is indicated by the corresponding part of the door open warning light.
Always make sure this light is not illuminated before you start to drive.
READ NEXT:
Windshield washer fluid warning light
This light illuminates when the fluid level in the windshield washer fluid tank
decreases to the lower limit (approximately 0.6 US qt, 0.6 liter, 0.5 Imp qt).
All-Wheel Drive warning light (AT and CVT models)
WARNING
Continued driving with the AWD warning light flashing can lead to powertrain
damage. If the AWD warning light flashes, promptly park in a safe place then check
whether all four tires ar
For AT models
This light flashes if the vehicle is driven with tires of different diameters
fitted on its wheels or with the air pressure excessively low in any of its tires.
SEE MORE:
Synthetic oil
You should use synthetic engine oil that meets the same requirements given for
conventional engine oil. When using synthetic oil, you must use oil of the same
classification, viscosity and grade shown in this Owner’s Manual. Refer to “Engine
oil” F12-4. Also, you must follow the oil and
Engine Control Module (ECM) I/O Signal
A: ELECTRICAL SPECIFICATION
Input/output name:
Crankshaft position sensor
Camshaft position sensor
Measuring condition:
After warming-up
At idling
Engine Condition Data
A: ELECTRICAL SPECIFICATION
Measuring condition:
After engine is warmed up.
Set the select lever in "P" range
© 2010-2024 Copyright www.suoutback.com
