Subaru Outback (BR): Engine - H4SO
Subaru Outback (BR) 2010-2015 Service Manual / Engine - H4SO
- Fuel Injection (Fuel Systems)
- General Description of Fuel Injection System
- Throttle Body
- Intake Manifold
- Crankshaft Position Sensor
- Knock Sensor
- Manifold Absolute Pressure Sensor
- Oil Temperature Sensor
- Main Relay
- Fuel (tank, pump, sensors)
- Emission Control (Aux. Emission Control Devices)
- Intake (Induction)
- Mechanical
- General Description of Mechanical
- Engine Assembly
- Engine Mounting
- Timing Belt Cover
- Cam Sprocket
- Cylinder Head
- Cylinder Block
- Oil Switching Solenoid Valve
- Exhaust
- Cooling
- Lubrication
- Speed Control Systems
- Ignition
- Starting/Charging Systems
- General Description of Starting-Charging Systems
- Starter
- Generator
- Battery (inspection, removal, installation)
- Engine (Diagnostics)
- Basic Diagnostic Procedure of Engine - H4SO
- Engine Control Module (ECM) I/O Signal
- Inspection Mode
- Drive Cycle
- Malfunction Indicator Light
- Diagnostic Procedure with Diagnostic Trouble Code (DTC)
- General Description (Diagnostic Trouble Code (DTC) )
- DTC P0026, P0028, P0030, P0031, P0032, P0037, P0038, P0068, P0076, P0077, P0082, P0083, P0101, P0102, P0103
- DTC P0107, P0108, P0111, P0112, P0113, P0117, P0118, P0122, P0123, P0125, P0126, P0128
- DTC P0131, P0132, P0133, P0134, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P014C, P014D, P015A, P015B
- DTC P0171, P0172, P0181, P0182, P0183, P0196, P0197, P0198, P0201, P0202, P0203, P0204, P0222, P0223, P0301, P0302, P0303, P0304
- DTC P0327, P0328, P0335, P0336, P0340, P0341, P0351, P0352, P0353, P0354, P0400, P0420
- DTC P0442, P0447, P0448, P0451, P0452, P0453, P0456, P0457, P0458, P0459, P0461, P0462, P0463, P0464
- DTC P0500, P0506, P0507, P050A, P050B, P0512, P0513, P0604, P0605, P0607, P0638, P0700, P0851, P0852
- DTC P1152, P1153, P1160, P1443, P1492, P1493, P1494, P1495, P1496, P1497, P1498, P1499, P1518, P1560, P1570, P1571, P1572, P1574, P1576, P1577, P1578
- DTC P2096, P2097, P2101, P2102, P2103, P2109, P2122, P2123, P2127, P2128, P2135, P2138, P2227, P2228, P2229, P2610
- DTC U0073, U0101, U0122, U0140, U0402, U0416, U0422
READ NEXT:
General Description of Fuel Injection System
A: SPECIFICATION
B: COMPONENT
1. INTAKE MANIFOLD
Intake manifold
Gasket
Intake manifold protector RH
Intake manifold protector LH
Fuel gallery RH
Fuel gallery LH
Throttle Body
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the cover (A) and clip (B) from air intake
boot assembly.
3) Loosen the clamp (A) which connects the air intake
boot assembly and ai
SEE MORE:
Relay and Fuse, check fuse
A: LOCATION
NOTE: For other related fuses, refer to the wiring diagram. <Ref. to WI-15, Power Supply Circuit.>
B: INSPECTION
1. CHECK FUSE.
1) Remove the fuse and inspect visually.
2) If the fuse is blown out, replace the fuse.
NOTE: If the fuse is blown again, check the system wiring
Battery (inspection, removal, installation)
A: REMOVAL
1) After disconnecting the battery ground terminal, remove the terminal cover, then disconnect the positive terminal.
2) Remove the battery cable holder from the battery rod.
3) Remove flange nut from the battery rod and remove battery holder.
Remove the battery.
B: INSTALLATION
© 2010-2026 Copyright www.suoutback.com
