Subaru Outback (BR): Lubrication
Subaru Outback (BR) 2010-2015 Service Manual / Engine - H4SO / Lubrication
READ NEXT:
General Description of Lubrication
A: SPECIFICATION
Non-turbo model
Recommended oil:
CAUTION: It is acceptable to fill an engine with oil of another brand when replacing the oil, but make sure to use the following engine
Oil Pressure System
A: WIRING DIAGRAM
B: INSPECTION
Engine Oil
A: INSPECTION
CAUTION:
If the engine oil is spilt over exhaust pipe or the
under cover, wipe it off with cloth to avoid emitting
smoke or causing a fire.
1
Oil Pressure Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the generator. <Ref. to SC(H4SO)-18,
REMOVAL, Generator.>
3) Disconnect the terminal from oil pressure switch.
4) Remove the
SEE MORE:
Checking the coolant level
Check the coolant level at each fuel stop.
1. Check the coolant level on the outside of the reservoir while the engine is
cool.
2. If the level is close to or lower than the “LOW” level mark, add coolant up to
the “FULL” level mark. If the reserve tank is empty, remove the radiator c
Top tether anchorages
Your vehicle is equipped with three top tether anchorages so that a child restraint
system having a top tether can be installed in the rear seat. When installing a
child restraint system using top tether, proceed as follows, while observing the
instructions by the child restraint system manufa
© 2010-2026 Copyright www.suoutback.com
