Subaru Outback (BR): Entertainment
READ NEXT:
A: CAUTION
Before disassembling or reassembling parts, always disconnect the battery ground cable from battery.
When replacing the audio, control module and other parts provided with m
A: REMOVAL
1. FRONT SIDE SPEAKER
1) Disconnect the ground cable from battery.
2) Remove the front side speaker.
Release the clips and claws, then detach the speaker cover.
CAUTION:
Use a plastic c
A: REMOVAL
1. SEDAN MODEL
NOTE:
harman/kardon audio system only.
1) Disconnect the ground cable from battery.
2) Remove the rear shelf trim. <Ref. to EI-120, REMOVAL, Rear Shelf Trim.>
3) Remo
SEE MORE:
A: NOTE
Yaw rate & longitudinal G and lateral G sensor are integrated with the VDC
control module & hydraulic control
module (VDCCM&H/U).
B: INSPECTION
1. YAW RATE & LONGITUDINAL G AND LATERAL G SENSOR SIGNAL
Steering Angle Sensor
A: REPLACEMENT
1) Position the front wheels straigh
A: PROCEDURE
Perform the diagnosis shown in the following DTC table.
When performing the diagnosis not listed in "List of Diagnostic Trouble Code (DTC)",
refer to the item on the
drive cycle. <Ref. to EN(H4SO)(diag)-45, Drive Cycle.>
1. PREPARATION FOR THE INSPECTION
MODE
1) Check that the
© 2010-2026 Copyright www.suoutback.com
