Subaru Outback (BR): Heater operation
NOTE
● When the “
” button or “
”
button is pressed the air conditioner compressor automatically operates to quickly
defog the windshield. However the indicator on the air conditioner button will not
illuminate. At the same time, the air inlet selection is automatically set to “outside
air” mode.
● Warm air also comes out from the right and left air outlets. To stop warm airflow
from these outlets, turn the corresponding wheel to the “
”
position.
READ NEXT:
Defrosting or defogging the windshield
To direct warm air to the windshield and front door windows:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Turn the temperature control dial all the way
Heating and defrosting
To direct warm air toward the floor and the windshield:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the temperature control dial to the most comfor
Heating
To direct warm air toward the floor:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the temperature control dial to the most comfortable level.
4. Se
SEE MORE:
Starting your vehicle
NOTE
All vehicle doors, the engine hood and trunk / rear gate must be closed prior
to activating the remote engine start system. Any open entry point will prevent
starting or cause the system to shut down.
The remote engine start function is activated by pressing the “”
button twice wi
Engine Mounting
A: REMOVAL
1) Change the front hood damper mounting position
from (A) to (B), and completely open the front
hood.
Tightening torque:
20 N*m (2.0 kgf-m, 14.8 ft-lb)
2) Disconnect the ground cable from battery.
3) Remove the radiator main fan motor assembly
and radiator sub fan motor assembly. <R
© 2010-2026 Copyright www.suoutback.com
