Subaru Outback (BR): Lighting System
Subaru Outback (BR) 2010-2015 Service Manual / Body / Lighting System
- General Description of Lighting System
- Combination Switch (Light)
- Headlight Assembly
- Headlight Bulb
- Front Side Marker Light Bulb
- Tail/Stop Light Bulb
- Back-up Light Bulb
- Spot Map Light
- Ignition Switch Illumination
READ NEXT:
General Description of Lighting System
A: SPECIFICATION
B: CAUTION
Before disassembling or reassembling parts, always disconnect the battery ground cable from battery.
When replacing the audio, control module and other par
Combination Switch (Light)
A: REMOVAL
1) Position the front wheels straight ahead. (After moving a vehicle 5 m (16
ft) or more with front wheels positioned
straight ahead, make sure that the vehicle moves straight ahead.)
2)
Headlight Assembly
A: REMOVAL
CAUTION:
Do not perform work with wet hands.
1) Disconnect the ground cable from battery.
2) Remove the clips and remove the air intake duct. (When removing the headlight
RH)
3) Remove t
SEE MORE:
Crankshaft Position Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the bolt which secures crankshaft position
sensor to oil pump.
3) Remove the crankshaft position sensor, and disconnect
the connector from the crankshaft position
sensor.
B: INSTALLATION
Install in the reverse order of removal.
Tig
Top tether anchorages
Your vehicle is equipped with three top tether anchorages so that a child restraint
system having a top tether can be installed in the rear seat. When installing a
child restraint system using top tether, proceed as follows, while observing the
instructions by the child restraint system manufa
© 2010-2026 Copyright www.suoutback.com
