Subaru Outback (BR): Power and sound controls
Subaru Outback (BR) 2010-2015 Owners Manual / Audio / Power and sound controls
READ NEXT:
Power switch and volume control
The dial is used for both power (ON/OFF) and volume control. The radio is turned
ON and OFF by pressing the dial, and the volume is controlled by turning the dial.
Tone and balance control
Each brief press of the “TUNE/TRACK/ CH” dial changes the control modes in the
following sequence.
Choose the desired level for each mode by turning the “TUNE/TRACK/CH” dial. The
cont
SEE MORE:
Front Fender
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the bumper face assembly.
Remove the clips, turn over the front mud guard, and disconnect the fog
light connector. (Model with
fog light)
Remove the clips at the upper side of the bumper.
Remove the clips from the fender.
Basic Diagnostic Procedure of LAN System
A: PROCEDURE
CAUTION:
Subaru Select Monitor is required for reading DTC, performing diagnosis, reading current data, customizing and active test (compulsory drive).
Remove foreign matter (dust, water, oil, etc.) from each control module connector during removal and installation.
© 2010-2026 Copyright www.suoutback.com
