Subaru Outback (BR): Vehicle Dynamics Control (VDC) (Diagnostics)
Subaru Outback (BR) 2010-2015 Service Manual / Chassis / Vehicle Dynamics Control (VDC) (Diagnostics)
- Basic Diagnostic Procedure of Vehicle Dynamics Control
- Subaru Select Monitor
- Warning Light Illumination Pattern
- Vehicle Dynamics Control - List of Diagnostic Trouble Code (DTC)
READ NEXT:
Basic Diagnostic Procedure of Vehicle Dynamics Control
A: PROCEDURE
CAUTION: Remove foreign matter (dust, water, oil etc.) from the VDCCM&H/U connector during removal and installation.
NOTE:
To check the harness for open or short circuits, s
Subaru Select Monitor
A: OPERATION
1. HOW TO USE SUBARU SELECT MONITOR
NOTE:
For detailed operation procedures, refer to "PC
application help for Subaru Select Monitor".
If VDC and Subaru Select Monitor cannot communic
Warning Light Illumination Pattern
A: INSPECTION
Ignition switch
OFF
ON
Engine start
ABS warning light
Light OFF
Light ON
2 sec.
VDC OFF indicator light
VDC warning light & VDC indicator
light
Several seconds (dependi
SEE MORE:
Basic Diagnostic Procedure of Vehicle Dynamics Control
A: PROCEDURE
CAUTION: Remove foreign matter (dust, water, oil etc.) from the VDCCM&H/U connector during removal and installation.
NOTE:
To check the harness for open or short circuits, shake problem spot or connector.
Refer to "Check List for Interview". <Ref. to VD
Cradle
A: REMOVAL
1) Set the vehicle on a lift.
2) Adjust the tilt position of the steering column to the lowest position and
lock the tilt lever.
3) Prevent the steering wheel from turning using the seat belt.
4) Remove the front wheels.
5) Disconnect the ground cable from battery.
6) Remove the air
© 2010-2026 Copyright www.suoutback.com
